DAB/FM aerial splitter
for existing passive aerials when using car radios with digital DAB+ receiver units
This DAB+ aerial splitter is required if you are upgrading your vehicle to a car radio with DAB+ receiver and a passive telescopic or rod aerial without integrated amplifier is already installed. This allows you to use this antenna for FM and DAB+ and avoids the need to install additional DAB+ antennas.
FEATURES
? Active DAB+ aerial splitter
? Plug & Play - easy installation
? Low noise amplifier
? Gold-plated SMB right-angle connector
? No need to install additional DAB aerials
? For FM aerials from 30 - 100cm length
TECHNICAL DATA
? Adapter length: approx. 34cm
? 1x SMB angle connector gold-plated
? 1x DIN aerial plug 150 Ohm
? 1x DIN aerial coupling 150 Ohm
? Supply voltage: 12 Volt
? Power consumption. 6 mA
? Noise figure: <2 dB
? Connect the blue cable to the remote output of the car radio.
IMPORTANT NOTES
? Not suitable for aerials with phantom power or disc aerials
? The aerial power must be switched off at the DAB unit