Cylinder head - 6 cylinder engine
exchange. Please note: the overhauling includes only the inlet section 'cause the exhaust valves are fitted to the cylinder block
Series IIA
Required: 1
exchange. Please note: the overhauling includes only the inlet section 'cause the exhaust valves are fitted to the cylinder block
Series III
Required: 1
Series IIA
Required: 1
Series III
Required: 1
retaining rocker cover
Required: 3
with engien breather
Required: 1
for ignition wire
Required: 2
lenght: 1.29/32"
Required: 6
length: 2.17/32"
Required: 3
length: 4.29/32"
Required: 8
length: 4.31/32"
Required: 3
retaining rocker cover
Required: 3
- 1.3/8" diameter
Please check before ordering
Required: 2
- 31,5 mm diameter
Please check before ordering
Required: 2
- 11/16" diameter
Please check before ordering
Required: 7
- 16,3 mm diameter
Please check before ordering
Required: 7
- 7/8" diameter
Please check before ordering
Required: 4
- 22,5 mm diameter
Please check before ordering
Required: 4
- 1" diameter
Please check before ordering
Required: 1
- 15/16" diameter
Please check before ordering
Required: 1
for vacuum hose between brake servo and inlet manifold
Required: 1
Required: 1
Required: 1
inlet valve
Required: 6
valve spring
Required: 6
Required: 3
- front position
Series IIA
Required: 1
- front position
Series III
Required: 1
- rear position
Series IIA
Required: 1
- rear position
Series III
Required: 1
- rear position RH
Series IIA
Required: 1
- rear position RH
Series III
Required: 1
inlet - rear shaft with 33 cm length
Required: 1
rocker shaft
Required: 6
for rockers
Required: 3
fot rocker shaft
Required: 3
retaining rocker shaft
Required: 3
retaining rocker shaft
Required: 3
inlet valve - two piece set with inner and outer spring
Required: 6
exhaust - inner and outer
Required: 6
adjusting screw
Required: 6
Cap
Required: 6
inlet - front shaft with 35 cm length
Required: 1
exhaust - rear shaft with 17 cm length
Required: 1
retaining rocker shaft
Required: 2
Required: 2
rocker shaft - lower position
Required: 6
Rocker, exhaust
Required: 6
rocker, inlet
Required: 6
inlet, LH cranked
Required: 3
Rocker shaft - thick
Required: 2
rocker shaft - thin
Required: 2
Required: 2
for cylinder head and engine block
Required: 1
