Inner body repair panels, rear section - MK4 and 1500
on floor panel - length: 17"
Required: 2
for floor panel stiffener plate
Required: 2
floor panel to chassis, LH side
Required: 1
floor panel to chassis, RH side
Required: 1
for seat belt mounting
Welded to sill
Required: 2
made from plastic
Alternatives
Required: 1
made from fibreglass
Alternatives
Required: 1
for anchoring handbrake lever
Welded to propshaft tunnel
Required: 1
propshaft tunnel
1500
Required: 1
cover to propshaft tunnel
1500
Required: 3
radius arm - must be weldede to the heelboard panel
Required: 2
inner LH 'B' post, lower section
Required: 1
inner RH 'B' post, lower section
Required: 1
LH rear
Required: 1
RH rear
Required: 1
LH rear inner wing - rear half
Required: 1
RH rear inner wing - rear half
Required: 1
LH rear inner wing - rear lower section
Required: 1
RH rear inner wing - rear lower section
Required: 1
RH rear - outer repair section
Required: 1
for seat belt mounting - supplied in pairs. Must be welded to the body (e.g. to the inner wheel arch). Size: 55 x 55 mm x 2 mm thickness with 7/16" UNF thread welded nut
Welded to inner wheel arch
Required: 1
rear
Required: 1
leaf spring access
Required: 1
No.10 with 5/8" length - galvanised screw with Phillips PZ2 cross slotted panhead
Required: 2
rear floor panel to chassis, LH side
Required: 1
rear floor panel to chassis, RH side
Required: 1
wheel arch to decking panel
Required: 2
fuel tank, LH side
Required: 1
fuel tank, RH side
Required: 1
fuel tank, LH side lower
Required: 1
lower bumper mounting
Required: 2
rear silencer to boot floor (RH fitting)
Required: 1
Ferpox - 1-part epoxy primer
Content: 800 ml (?45.80 / 1000 ml)
