Inner body repair panels, rear section - TR4 and TR4A
LH rear - variant without bulge for seat belt bracket
TR4A
Required: 1
RH rear - variant without bulge for seat belt bracket
TR4A
Required: 1
Spare wheel tray
Required: 1
wiring loom securing
For welding to inner wing and inner sill
LH fuel tank support
Required: 1
RH fuel tank support
Required: 1
vertical squab support
Required: 2
LH rear floor to wheel arch
Required: 1
RH rear floor to wheel arch
Required: 1
rear quarter panel
Required: 4
fuel tank to body
Required: 2
rear. Please note: The assembly includes the brackets to which the rear cockpit trim panel/'fuel tank board' is secured. It does not, however, include the rear axle differential cover 'bulge', which must be recovered from the old rear seat pan being replaced and welded to the new panel
Required: 1
to rear floor
Required: 2
rear tunnel cover to heelboard
TR4A
Required: 1
handbrake cable - made from cardboard
TR4A
Required: 1
handbrake cable - made from GFK
TR4A
Required: 1
for anchoring handbrake lever
TR4A
Required: 1
TR4
Required: 1
TR4A
Required: 1
inner sill to LH rear chassis outrigger
Required: 1
inner sill to RH rear chassis outrigger
Required: 1
inner sill to front chassis outrigger
Required: 2
two piece plastic replacement
Required: 1
one piece plastic replacement
Required: 1
one piece fibreglass replacement
Required: 1
on gearbox tunnel for speedo cable access. Fibreglass reproduction
Required: 1
Required: 3
securing seat belt on wheel arch
Required: 2
securing seat belt on inner sill
Required: 2
LH rear axle bump stop
Required: 1
RH rear axle bump stop
Required: 1
