Cylinder block and oil filter 2.25 petrol engine
for immersion heater boss on cylinder block
Required: 1
oil gallerie, front position
Required: 1
wing type made from steel - with 9/16" BSP thread
Alternativ
Required: 1
in cylinder block - feature: metric thread
Required: 1
main bearing cap - stretch bolt with 9/16" UNF thread and 3.1/4" length
Vehicles with 3 main bearings
Required: 6
main bearing cap - stretch bolt with 9/16" UNF thread and 3.1/4" length
Vehicles with 5 main bearings
Required: 10
Vehicles with 5 main bearings
Required: 10
main bearing cap
Vehicles with 3 main bearings
Required: 6
main bearing cap
Vehicles with 5 main bearings
Required: 10
retaining timing cover
Series II models
Required: 1
retaining timing cover
Series II models
Required: 1
Series IIA models
Required: 1
retaining flywheel housing to cylinder block
Vehicles with 3 main bearings
Required: 2
retaining flywheel housing to cylinder block
Vehicles with 5 main bearings
Required: 2
- RH
To engine no.151023739
Required: 1
- RH
From engine no.151023740
Required: 1
- LH
To engine no.151023739
Required: 1
- LH
From engine no.151023740
Required: 1
- LH
Series III
Required: 1
retaining engine bracket to cylinder block - short, imperial
Required: 3
retaining engine bracket to cylinder block - long, imperial
Required: 1
retaining engine bracket to cylinder block - short, metric
Required: 3
retaining engine bracket to cylinder block - long, metric
Required: 1
flywheel housing
Vehicles with 3 main bearings
Required: 1
clutch housing
Vehicles with 5 main bearings
Required: 1
drain plug
Required: 1
retaining flywheel housing, imperial
Required: 14
retaining inspection cover plate
Series II and IIA
Required: 2
inspection aperture
Series II and IIA
Required: 1
inspection aperture
Series II and IIA
Required: 1
with breather - front position
Required: 1
retaining side cover - front position, metric
Required: 6
- rear position
Series II, IIA and Serie III with engine prefix 901 and 904 and engine prefix 361 and 364 suffix A and B only
Required: 1
with filler neck - rear position
Series III from engine prefix 901 and 904, suffix C and D inclusive
Required: 1
with filler neck - rear position
Series III from engine prefix 901 and 904 suffix E and all prefix 361 and 364
Required: 1
without breather, yellow galvanized, diameter: 58 mm
Series III from engine prefix 901 and 904, engine suffix C and D inclusive
Required: 1
- imperial
Required: 2
retaining side cover - rear position, imperial
Required: 6
retaining side cover - rear position, metric
Required: 6
paper. Total height 174 mm diameter inner hole 19 mm
Required: 1
paper. Total height 118 mm diameter inner hole 32 mm
Required: 1
oil filter - lower position
Required: 1
retaining oilfilter to cylinder block - imperial
Required: 2
retaining oilfilter to cylinder block - metric
Required: 2
Series II
Required: 1
oil pipe to cylinder head - feature: imperial thred
Series II and IIA
Required: 2
oil pipe to cylinder haead and to engine block- feature: M10x1.5 standard thread
Required: 2
oil feed pipe - imperial
Required: 4
