Inner body repair panels, rear section - TR6
spare wheel tray
Required: 1
boot floor to chassis frame
Required: 2
wiring loom securing
For welding to inner wing and inner sill.
electrical earth
For welding to LH inner wing
Required: 1
fuel tank support, LH
Required: 1
fuel tank support, RH
Required: 1
vertical squab support
Carburettor to CC32142, P.I. to CP26998
Required: 2
vertical squab support, LH
Carburettor from CC50001, P.I. from CP50001
Required: 1
vertical squab support, RH
Carburettor from CC50001, P.I. from CP50001
Required: 1
LH rear floor to wheel arch
Required: 1
RH rear floor to wheel arch
Required: 1
rear. Please note: The assembly includes the brackets to which the rear cockpit trim panel/'fuel tank board' is secured. It does not, however, include the rear axle differential cover 'bulge', which must be recovered from the old rear seat pan being replaced and welded to the new panel
Required: 1
to rear floor
Required: 2
fuel tank to body
Required: 2
securing seat belt on wheel arch
Required: 2
securing seat belt on inner sill
Required: 2
LH rear axle bump stop
Required: 1
RH rear axle bump stop
Required: 1
rear tunnel cover to heelboard
Required: 1
rear
Required: 1
for anchoring handbrake lever
Required: 1
handbrake cable - made from cardboard
Alternatives
Required: 1
handbrake cable - made from fibreglass
Alternatives
Required: 1
two piece plastic replacement
Alternatives
Required: 1
one piece plastic replacement
Required: 1
one piece fibreglass replacement
Alternatives
Required: 1
on gearbox tunnel for speedo cable access. Fibreglass reproduction
For speedo cable access
Required: 1
For speedo cable access
Required: 3
inner sill to LH rear chassis outrigger
Required: 1
inner sill to RH rear chassis outrigger
Required: 1
inner sill to front chassis outrigger
Required: 2
110 pieces, imperial and metric, No. 4 to 3/4" and M6 to M18, 2 tap wrenches, 2 die holders, tungsten steel
Comes in a nicely finished metal box
Required: 1
