Handbrake - XK150 from May 1960
between shaft and handbrake lever
Required: 1
handbrake warning light switch
Required: 1
bracket to propshaft tunnel
Required: 2
locating idler lever and operating lever on handbrake shaft
Required: 2
1.1/2" x 5/16" UNF
Securing idler lever and operating lever to handbrake shaft
Required: 2
Securing idler lever and operating lever to handbrake shaft
Required: 2
Securing idler lever and operating lever to handbrake shaft
Required: 2
Control rod to compensator bracket
Required: 1
Control rod to compensator bracket
Required: 1
Control rod to compensator bracket
Required: 1
Control rod to compensator bracket
Required: 1
handbrake cable to compensator bracket
Required: 2
Clinching handbrake cable in abutment plate
Required: 2
Clinching handbrake cable in abutment plate
Required: 2
Clinching handbrake cable in abutment plate
Required: 2
Securing abutment plate to chassis frame
Required: 4
Securing abutment plate to chassis frame
Required: 4
handbrake cable to rear axle
Required: 2
Handbrake cable to operating lever
Required: 2
Handbrake cable to operating lever
Required: 2
Handbrake cable to operating lever
Required: 2
extreme water resistant grease for handbrake cables, leaf springs and wire wheel adaptors
Required: 1
Content: 500 g (?21.68 / 1000 g)