SU-HS2 internal carburettor MK4- all European specifications from November 1970 to December 1974
with valve
From engine no. FH25001
Required: 2
throttle spindle. For bodies with worn cast in bushes, useable on SU HS2 carburettors with 5/16" throttle spindle
For bodies with worn cast in bushes
Required: 4
throttle spindle on front and rear carburettor - stainless steel reproduction
Required: 2
choke lever - front carburettor
Required: 1
choke lever - rear carburettor
Required: 1
and link - front carburettor
Required: 1
and link - rear carburettor
Required: 1
front carburettor
Required: 1
for SU HS type carburettor - uprated 'unsinkable' type, made from closed cell Nitrile rubber foam, resistant to modern ethanol based fuels
Required: 2
for SU carburettors - bore: 0.096"
Required: 2
for SU-H, SU-HD and SU-HS type carburettors - superior replacement of needle valve and seat
Superior replacement of needle valve and seat. This valve is less likely to stick open or over fuel on run over
Required: 2
front carburettor
Carburettors with reference no. AUD441 and AUD517
Required: 1
rear carburettor
Carburettors with reference no. AUD441 and AUD517
Required: 1
front carburettor
Carburettors with reference no. AUD580
Required: 1
rear carburettor
Carburettors with reference no. AUD580
Required: 1
front carburettor
Carburettors with reference no. AUD624
Required: 1
rear carburettor
Carburettors with reference no. AUD624
Required: 1
piston return - colour: red, spring rate: 4.5 oz
Standard type
Required: 2
piston return - colour: yellow, spring rate: 8 oz
Uprated type
Required: 2
spring loaded type - marked: AAN
For standard mixture
Required: 2
spring loaded type - marked: AAT
For weak mixture
Required: 2
spring loaded type - marked: ABY
For rich mixture
Required: 2
front carburettor - diameter: 0.090"
Required: 1
rear carburettor - diameter: 0.090"
Required: 1
choke lever to main jet
Required: 2
with 3/8"-40 UNS fine threat - SU-HS carburettors with spring loaded metering needle
Required: 2
Part of our jet bearing kit 1434 (ill. 48)
Required: 2
jet bearing
Part of our jet bearing kit 1434 (ill. 48)
Required: 2
jet bearing
Part of our jet bearing kit 1434 (ill. 48)
Required: 2
for mixture adjusting on main jet - variant with 3/8"-26 BSB coarse threat
Part of our jet bearing kit 1434 (ill. 48)
Required: 2
for two SU-HS2 type carburettors. Comprising service kit 214281 plus throttle discs and throttle spindles
Required: 1
