Inner body repair panels, rear section - TR5 and TR250
LH rear
OE version to adapt seat belt bracket
Required: 1
RH rear
OE version to adapt seat belt bracket
Required: 1
LH rear - variant without bulge for seat belt bracket
Required: 1
RH rear - variant without bulge for seat belt bracket
Required: 1
spare wheel tray
Required: 1
boot floor to chassis frame
Required: 2
wiring loom securing
For welding to inner wing and inner sill.
LH fuel tank support
Required: 1
RH fuel tank support
Required: 1
vertical squab support
Required: 2
LH rear floor to wheel arch
Required: 1
RH rear floor to wheel arch
Required: 1
rear quarter panel
Required: 4
fuel tank to body
Required: 2
rear. Please note: The assembly includes the brackets to which the rear cockpit trim panel/'fuel tank board' is secured. It does not, however, include the rear axle differential cover 'bulge', which must be recovered from the old rear seat pan being replaced and welded to the new panel
Required: 1
to rear floor
Required: 2
rear tunnel cover to heelboard
Required: 1
handbrake cable - made from cardboard
Alternatives
Required: 1
handbrake cable - made from fibreglass
Alternatives
Required: 1
for anchoring handbrake lever
Required: 1
Required: 1
inner sill to LH rear chassis outrigger
Required: 1
inner sill to RH rear chassis outrigger
Required: 1
inner sill to front chassis outrigger
Required: 2
two piece plastic replacement
Alternatives
Required: 1
one piece plastic replacement
Required: 1
one piece fibreglass replacement
Alternatives
Required: 1
on gearbox tunnel for speedo cable access. Fibreglass reproduction
Required: 1
Required: 3
securing seat belt on wheel arch
Required: 2
securing seat belt on inner sill
Required: 2
LH rear axle bump stop
Required: 1
RH rear axle bump stop
Required: 1
