body panels and fittings
RH front wing, nose section
Required: 1
RH front wing, indicator section
Required: 1
RH front wheel arch - width: approx. 13 cm
Required: 1
RH front wing, rear half only
Required: 1
LH front wing, nose section
Required: 1
LH front wing, indicator section
Required: 1
LH front wheel arch - width: approx. 13 cm
Required: 1
LH front wing, rear half only
Required: 1
footwell to RH front wing
Required: 1
footwell to LH front wing
Required: 1
joining front wings to grille
Required: 2
RH - repair panel without step
Required: 1
LH - repair panel without step
Required: 1
LH front door
Required: 1
'D' post, RH side - variant with Dzus fasteners for wheel spat
Required: 1
'D' post, LH side - variant with Dzus fasteners for wheel spat
Required: 1
for vehicles with wide bumper
Mark II 3.4 and 3.8 (1959-67)
Required: 1
for vehicles with wide bumper
Mark II 2.4 (1959-67)
Required: 1
for vehicles with narrow bumper
Mark II 240 and 340 (1967-69)
Required: 1
for vehicles with wide bumper
Daimler 2.5 V8 Saloon to chassis no. 1A12497 and 1A20557 (1962-67)
Required: 1
for vehicles with narrow bumper
Daimler 2.5 V8 "250" Saloon from chassic no. 1K1001 and 1K30001 (1967-69)
Required: 1
RH rear - 'Coombs' type
Alternatives
Required: 1
LH rear - 'Coombs' type
Alternatives
Required: 1
rear - 'Coombs' type in fibreglass. Supplied in pairs
Alternatives
Required: 1
RH chassis leg with 60 cm length - from front to just behind 'V' block mounting
From front to just behind 'V' block mounting
Required: 1
LH chassis leg with 60 cm length - from front to just behind 'V' block mounting
From front to just behind 'V' block mounting
Required: 1
R/H floor
Above front jacking point
Required: 1
L/H floor
Above front jacking point
Required: 1
on screw securing gearbox cover
Required: 11
panhard rod
For R/H spring hanger
Required: 1
rear leaf spring
For L/H spring hanger
Required: 1
boot lid
Approx 10" from bottom edge
Required: 1
RH rear inner corner with bumper mounting
Required: 1
LH rear inner corner with bumper mounting
Required: 1
boot lock. Comes with button and two keys
long pozi headed
Per top rear hinge (fixing door to hinge)
Required: 4
5/8" x 5/16" UNF thread - with cross slotted cheese head and pointed end, galvanised
Per front hinge (fixing hinge to 'A' post). 3 required per rear hinge (fixing hinge to 'C' post).
Required: 2
pointed hinge
Per front hinge (fixing door to hinge). 3 required per bottom rear hinge (fixing door to hinge).
Required: 3
pointed hinge
Per front hinge (fixing hinge to 'A' post)
Required: 1
front-R/H upper and L/H lower
Required: 2
front door - RH lower and LH upper - used item
Required: 2
rear-R/H lower
Required: 1
