Cylinder block - XK120
- used item
To engine no. W2011
Required: 1
- used item
From engine no. W2012
Required: 1
cylinder head, with alignment dowel - length: 6.1/2"
Required: 1
cylinder head - length: 6.13/16". Variant with 9/16" UNF thread on block side for badly worn cylinder blocks
With 9/16" UNF thread on block side for badly worn cylinder blocks
cylinder block RH and LH sides - 1"
Required: 2
cylinder block each side and rear end - 1.3/4"
Required: 7
oil gallery - galvanised version with 1/2" UNF thread, fitted to the RH side of the cylinder block
Required: 6
oil gallery - brass version with 1/2" UNF thread, fitted to the RH side of the cylinder block
Required: 6
on LH side of cylinder block
Required: 1
in cylinder block - diameter: 5/16"
Required: 2
crankshaft to cylinder block
Required: 1
rear cover
Required: 1
- length: 7/8"
Rear cover to cylinder block
Required: 1
- length: 1.1/8"
Rear cover to cylinder block
Required: 2
Rear cover to cylinder block
Required: 3
rear crankshaft cover to cylinder block - diameter: 5/16"
Required: 2
securing sealing ring to rear cover
Required: 2
crankshaft rear - for vehicles with steel oil sump with groove in the rear recess of the oil sump. It is mounted on the inner side of the crankshaft flange, so the crankshaft needs to be processed at the former sealing surface. During an engine overhaul these changes can be easily done while grinding the crankshaft
Required: 1
in cylinder block - diameter: 5/16"
Required: 14
rear main bearing cap
Required: 1
sealing aperture for heater element
Cars without heater
Required: 1
Oil feed pipe from cylinder block to head
Required: 2
securing oil feed pipe
Oil feed pipe from cylinder block to head
Required: 1
securing oil feed pipe - repair bolt length: 1.1/4"
Oil feed pipe from cylinder block to head
Required: 1
crankshaft front - two-piece
Required: 1
crankshaft front - two-piece modern high tech cometic version
Required: 1
crankshaft front. Please note: no machining necessary
Please note: included a template for timing cover modification required
Required: 1
in cylinder block, behind chain tensioner
Required: 1
water pump
Part of our conversion gasket set 203081.
Required: 1
timing cover, two-piece
Part of our conversion gasket set 203081.
Required: 1
two-piece
Part of our conversion gasket set 203081 (ill. 52)
Required: 1
matt black
Quantity as required
Content: 400 ml (?30.00 / 1000 ml)