Fan, air baffles and thermostat housing
for fan wheel - models with dynamo
126, 1. Series (1972-76)
Required: 1
for fan wheel - models with three-phase alternator
126, 2. Series (1977-87)
Required: 1
engine cooling - standard version made of sheet metal
Required: 1
engine cooling - reproduction made from aluminium
Required: 1
engine cooling - reinforced and balanced version made from sheet metal
Required: 1
for fan - conical
126, 1. Serie (1972-76)
Required: 1
for fan wheel, conical - models with three-phase alternator
126, 2. Series (1977-87)
Required: 1
engine cooling - lower panel to oil sump
126, 1st Series (1972-76)
Required: 1
engine cooling, for models with dynamo
126, 1st Series (1972-76)
Required: 1
engine cooling, for models with alternator. Front half, facing the rear of the vehicle
126, 2nd Series (1977-87)
Required: 1
engine cooling - for models with alternator. Rear half, facing the front of the vehicle
126, 2nd Series (1977-87)
Required: 1
engine cooling - including air filter bracket
Required: 1
for engine cooling cold air hose
Required: 2
dynamo and alternator to air duct housing
Required: 2
dynamo and alternator to air duct housing
Required: 2
dynamo and alternator to air duct housing
Required: 2
top cover to air duct housing
Required: 8
air duct housing to thermostat housing
Required: 6
air duct housing to thermostat housing
Required: 6
air duct housing to thermostat housing
Required: 6
without thermostat, flap and lid
Required: 1
without thermostat, flap and lid
126, 2nd Series: German models with square cylinder head only (1977-87)
Required: 1
thermostat housing to cylinder head
Required: 2
thermostat housing to cylinder head
Required: 2
reproduction of the original, filled with alcohol
126, 1st Series (1972-76)
Required: 1
modern variant, without alcohol filling
126, 1st and 2nd series (1972-87)
Required: 1
thermostat housing - with air flap but less thermostat
Required: 1
thermostat to air flap - complete unit with screw
Required: 1
for air flap shaft. 2-piece set for thermostat housing repair
Required: 1
for pulley on models with dynamo
126, 1st Series (1972-76)
Required: 1
for pulley on models with alternator - used item
126, 2nd Series (1977-87)
Required: 1
cylinder head
Carbon Monoxide (CO) Safety Screw The air-cooled Fiat models 500 and 126 use the cooling air directly for heating. To prevent passengers from being poisoned with carbon monoxide unnoticed in the event of a defect in the cylinder head gasket, a duct directs the contaminated air out through a banjo bolt with a whistling sound. This vent screw has a double function as a fastening element for the thermostat housing. Unfortunately, in many cars the banjo bolts are replaced with normal M8 bolts. In the event of damage to the cylinder head gasket, this is life-threatening for the driver and passengers! Make sure that your vehicle is fitted with the original CO safety screw.
Required: 1
