Wheel bearings and drive shafts
rear, including large spacer bushing - made in Italy
Required: 2
rear, including large spacer bushing - aftermarket quality
Required: 2
rear wheel bearing - height: 32.7 mm
Required: 2
rear wheel bearing - height: 11.3 mm
Required: 2
with hub - identified by fine toothing
Required: 2
for bearings - max. diameter 3.1/2" (89 mm)
Required: 1
drive shaft to stub axle shaft
Required: 2
drive shaft to stub axle shaft - identified by fine toothing. Reinforced varinat
Required: 2
for drive shafts with 24 and 25 mm diameter
Required: 2
for drive shaft with 24 mm diameter
Required: 2
for drive shaft with 24 mm diameter and 4-hole attachment
Required: 2
for drive shaft with 24 mm diameter and 4-hole attachment - 2-piece kit
Required: 1
drive flange to sleeve yoke - set for one flange
Required: 2
with aluminium bush - for drive shaft with 24 mm diameter
Required: 2
with aluminium bush - reinforced version for drive shaft with 24 mm diameter
Required: 2
with plastic bush - for drive shaft with 24 mm diameter
Required: 2
drive shaft gaitor - new old stock
Required: 2
drive shaft gaitor - used item
Required: 2
for drive shaft with 24 mm diameter
Required: 2
with 24 mm diameter and 445 mm total length
Required: 2
with 24 mm diameter and 445 mm total length. Two shafts 'made in Italy' including drive flanges and all needed fittings
Required: 2
with 24 mm diameter and 445 mm total length. Two aftermarket shafts including drive flanges and all needed fittings
Required: 1
for locating key on drive shaft
Required: 4
