Gearbox - outer
gearbox to engine and starter motor retaining - length: 62 mm
Required: 2
bell housing to gearbox casing
Required: 1
bell housing
Required: 1
bell housing to gearbox casing - length: 95 mm
Required: 4
bell housing to gearbox casing - length: 85 mm
Required: 2
bell housing to gearbox casing
Required: 5
gearbox casing - for selector shaft stop
Required: 1
side cover to gearbox casing
Required: 2
between gearbox casing and gearbox extension
Required: 1
gearbox extension to casing
Required: 2
gearbox extension to casing
Required: 2
between gearbox casing and gearbox extension
Required: 1
gearbox extension to casing
Required: 2
first motion shaft. Complete unit with oil seal and bronce bearing
Required: 1
assembly - reconditioned, in exchange
Required: 1
Required: 1
in black plastic - mushroom-shaped version
126, 1st series (1972-76) - can also be used for 2nd series models
Required: 1
in black plastic - round version
126, 1st series (1972-76) - can also be used for 2nd series models
Required: 1
with short shaft
126, 2nd Series (1976-84)
Required: 1
with long shaft
126, 2nd Series (1984-87)
Required: 1
front
Required: 1
connecting gear lever with selctor fork rods
Required: 1
selector shaft
Required: 1
gear lever to selector shaft
Required: 1
and nut - connecting rod to selector shaft
Required: 1
without mounting bracket
126, 1st Series (1972-76)
Required: 1
without mounting bracket
126, 2nd Series (1976-87)
Required: 1
without front oil seal
Required: 1
speedo cable - identified by 15 teeth
Required: 1
angle drive - set of two pinons with 15 teeth each
Required: 1
