Radiator and radiator hoses - 4.2 Series 1 and RHD Series 1.5
new item with high efficiency core
E-Type 4.2 Series 1 with manual transmission (1964-68)
Required: 1
standard specification - reconditioned, in exchange
E-Type 4.2 Series 1 with manual transmission
Required: 1
alloy, lightweight type with high efficiency core
E-Type 4.2 Series 1 with manual transmission (1964-68)
Required: 1
made from aluminuim with polished finish, lightweight type with fantastic finish and high efficiency core - made in the UK
E-Type 4.2 Series 1 with manual transmission (1964-68)
Required: 1
new item with standard copper core
Series 1 4.2 litre 2+2 models with automatic transmission to 1E77644 (1966-67)
Required: 1
alloy, lightweight type with high efficiency core
Series 1 4.2 litre 2+2 models with automatic transmission to 1E77644 (1966-67)
Required: 1
retaining bracket to radiator cowl
Required: 2
retaining bracket to radiator cowl
Required: 2
retaining bracket to radiator cowl
Required: 2
radiator - aluminium reproduction
Required: 1
in stainless steel - under radiator
Required: 1
radiator cowl to radiator - in stainless steel
Required: 2
retaining air duct panel to radiator
Required: 2
retaining air duct panel to radiator
Required: 2
engine cooling system. Steel version, finished in grey hammerite
Required: 1
engine cooling system. Brass version of the original tank
Required: 1
engine cooling system. Ultra-light aluminium version of the original tank
Required: 1
radiator - pressure: 7 PSI, 3/4" depth
Required: 1
radiator - pressure: 13 PSI, 3/4" depth
Required: 1
retaining bracket to expansin tank
Required: 2
fan motor. Variant with single spade terminal. Switches on at 86 C¡ã and off at 74 C¡ã
Required: 1
fan motor. Variant with single spade terminal. Switches on at 90 C¡ã and off at 80 C¡ã
Required: 1
fan motor. Variant with twin spade terminal
Required: 1
fan motor. Complete unit with gasket and twin spade connector
Required: 1
reconditioned, in exchange
Required: 1
retaining heater motor heater motor
Required: 4
retaining heater motor heater motor
Required: 4
radiator to epansion tank, RH
Required: 1
radiator to epansion tank, LH
Required: 1
between header tank and thermostat housing
Required: 1
worm type. Retaining hose between header tank and thermostat housing
Required: 2
radiator to water pipe - lower position
Required: 1
conecting bottom radiator hoses - reproduction in stainless steel
Required: 1
between water pump and water pipe
Required: 1
worm type. Retaining water pump to hose
Required: 1
worm type. Retaining bypass hose to radiator and water pipe
Required: 2
worm type. Retaining hose to inlet manifold
Required: 1
worm type. Retaining hose to water pipe
Required: 1
with fabric interlayer for reinforcement
Required: 1
made of high quality silicone. Set with 13 lines incl. heater hoses
Required: 1
between radiator and bypass hose to inlet manifold
Required: 1
