Cylinder head - V8 Petrol
inlet manifold - modern Composite gasket
Required: 1
retaining bracket support ignition leads
Required: 1
ignition leads - LH
Required: 1
inlet manifold gasket ends - standard specification
Required: 2
grey
Required: 1
retaining bracket support ignition lead
Required: 2
retaining bracket support ignition lead
Required: 1
Required: 1
rocker cover to cylinder head - long
Required: 4
rocker cover to cylinder head - short
Required: 4
rocker shaft
Required: 4
RH side, made from alloy - use with push rod 369293 (don't use the standard push rod)
Required: 8
LH side, made from alloy - use with push rod 369293 (don't use the standard push rod)
Required: 8
suitable for steel and alumium rockers
Required: 16
cylinder head - is attached to the front
Vehicles without power steering and air conditioning
Required: 1
- front position
Vehicles with power steering and air conditioning
Required: 1
inlet and exhaust valve. Steel type
Required: 16
tapped for screw securing dipstick tube bracket
Required: 1
Vehicles without air conditioning
Required: 14
Vehicles with air conditioning
Required: 13
exchange - compression ratio: 8.13:1. Non detoxed variant
Vehicles with engine suffix 14G and 20G
Required: 2
exchange. Complete with valve guides, valves and springs
Vehicles with engine suffix 15G, 17G, and 21G
Required: 2
exchange - compression ratio: 8.13:1. Detoxed variant with injector tubes
Vehicles with engine suffix 24G
Required: 2
lifting bracket to cylinder head
Vehicles without power steering
Required: 2
lifting bracket to cylinder head
Vehicles with air conditioning and power steering
Required: 3
Vehicles without power steering
Required: 2
Vehicles with air conditioning and power steering
Required: 3
made from sheet metal. Bore size: 89.9 mm, thickness: 0.2"
Required: 2
classic soft material gasket on metal layer. Bore size: 89.9 mm, thickness: 0.43"
Required: 2
Composite specification with partial serigraph covering. Bore size: 88.9 mm + 0.5 mm, thickness: 0.47", built in thickness: 0.47"
Required: 2
stainless steel, diameter: 1.34" - for 8.13:1 compression engines
Required: 8
stainless steel, diameter: 1.57"- for 8.13:1 compression engines
Required: 8
with tin head gaskets
Required: 1
with soft material head gaskets on metal layer
Required: 1
Required: 1
non-setting gasket and jointing compound
Required: 1
Content: 80 ml (?125.12 / 1000 ml)
