Cylinder block BN1 and BN2
Dynamo bracket to cylinder block
Required: 4
Dynamo bracket to cylinder block
Required: 4
dipstick - screwed into cylinder block
Required: 1
cover
Required: 3
cylinder block, rear upper
Required: 1
on LH side of cylinder block
Required: 1
Required: 1
tachometer drive cover - short
Required: 1
tachometer drive cover - long
Required: 1
side cover
Required: 1
front
Required: 1
cylinder block, dish type - 1.5/8"
Required: 5
oil thrower
Required: 1
engine back plate
BN1 from 226095, BN2
Required: 2
rear engine plate
Required: 1
rear
Required: 1
crankcase vent
Required: 1
engine plate to engine block
Required: 8
Required: 1
blanking unused holes in cylinder block
Required: 2
engine plate to main bearing cap
BN1 from 226095, BN2
Required: 2
Required: 1
fuel pump drive aperture
Required: 1
on engine
Required: 2
for engine mounting
Required: 2
bracket to engine plate
Required: 4
bracket to cylinder block
Required: 4
on chassis
Required: 2
standard specification
Alternatives
Required: 8
standard specification with 230¡ã - new item
Required: 1
standard specification with 230¡ã - reconditioned, in exchange
Required: 1
266¡ã 100M specification - new item. Power band 1600 to 5500 rmp, valve timing 35/69 and 69/35, inlet valve full lift 107¡ã, cam lift 0.26", valve lift 0,369", valve clearance 0.015"
Required: 1
266¡ã 100M specification - exchange item. Power band 1600 to 5500 rmp, valve timing 35/69 and 69/35, inlet valve full lift 107¡ã, cam lift 0.26", valve lift 0,369", valve clearance 0.015"
Required: 1
supplied in sets of 3
Please note: may need line reaming after fitment
Required: 1
made from rubber
Required: 1
distributor and oil pump spindle bore - original type
Required: 2
distributor and oil pump spindle bore - replica without female hex hole
Required: 2
reconditioned with new ring gear, in exchange
Required: 1
in crankshaft to adapt flywheel bolt
Required: 4
Part of tachometer drive 326501 (Abb. 106)
Required: 1
tachometer
Part of tachometer drive 326501 (Abb. 106)
Required: 1
Part of tachometer drive 326501 (Abb. 106)
Required: 1
tachometer drive
Part of tachometer drive 326501 (Abb. 106)
Required: 1
Part of tachometer drive 326501 (Abb. 106)
Required: 1
Part of tachometer drive 326501 (Abb. 106)
Required: 1
BMC green
Required: 2
Content: 400 ml (?42.50 / 1000 ml)
metallic green (steel dust grey)
Required: 2
Content: 400 ml (?73.33 / 1000 ml)
metallic green (steel dust grey)
Required: 1
Required: 2
oil pressure operating valve
Required: 1
oil pressure operating valve - used item
Required: 1
cylinder block - kit with 8 plugs
Required: 1
