Cylinder block and oil filter 2.0 diesel engine Serie II
main bearing cap
Required: 6
wing type made from steel - with 9/16" BSP thread
Required: 1
retaining flywheel housing to cylinder block
Required: 2
oil gallerie, front position
Required: 1
retaining front cover to cylinder block
Required: 1
retaining front cover
Required: 1
- RH
Required: 1
- LH
Required: 1
retaining inspection cover plate
Required: 2
inspection aperture
Required: 1
inspection aperture
Required: 1
retaining flywheel housing to cylinder block
Required: 2
retaining flywheel housing to cylinder block
Required: 6
retaining starter motor
Required: 2
retaining engine bracket to cylinder block - short
Required: 3
retaining engine bracket to cylinder block - long
Required: 6
Required: 4
drain plug
Required: 1
with oil filler neck - front position
Required: 1
- rear position
Required: 1
retaining side cover - rear position, short
Required: 5
retaining side cover - rear position, long
Required: 1
retaining fuel pump
Required: 2
paper. Dimensions: outer diameter 92 mm, total height 174 mm diameter inner hole 19 mm
Required: 1
paper. Dimensions: outer diameter 92 mm, total height 118 mm diameter inner hole 32 mm
Required: 1
retaining oil filter bowl to cylinder block
Required: 2
to cylinder block
Required: 1
oil pipe to cylinder head - feature: imperial thred
Required: 2
without illustration
Required: 1
